Robe LiteWare HO Especificações Página 7

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 11
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 6
LiteWare HO
7
Run times for HO when on full white
Percentage of maximum output
Number of
pushes of top button
Run
time (hh:mm)
100
7:21
90
1
7:53
80
2
9:58
70
3
13:35
60
4
17:48
50
5
27:38
40
6
67:21
3.3 The controls and display
On the bottom of the battery base unit are the UP and DN buttons, and the ADDRESS display panel.
UP and DN buttons
The UP and DN buttons are used to select an address.
Button
Behaviour
Up
Increments the address by 1.
DN
Decrements the address by 1 (001 is the lowest value).
Tip: The casing of the battery base unit is cut away at the bottom which allows these buttons to be
reached even when the battery base unit is standing vertically upright.
Fast address searching and address boundaries
If you press and hold the UP or DN button the address changes slowly then gradually speeds up. When
the end of an address range is reached (see below) the address stays at that value. To select an
address in the next range, release the button then use the UP or DN button again.
Fast searching and address ranges provide an easy way to select addresses quickly. The address ranges
for both wireless DMX and stand-alone modes summarised in the table below. See page 9 for
detailed descriptions of the stand-alone address ranges.
Range
What
0
01
-
512
Wireless DMX mode address
601
-
650
Fixed colours (stand
-
alone mode)
651
-
655
Colour fade sequence 1 (stand
-
alone mode)
656
-
660
Colour fade sequence 2 (stand
-
alone mode)
661
-
665
Colour snap sequence 1 (stand
-
alone mode)
666
-
670
Colour snap sequence 2 (stand
-
alone mode)
The address display panel
The address panel displays the current address. The display goes mostly blank after five seconds of
button inactivity. Press either the UP or DN button to wake the unit up.
When the display goes mostly blank, there are a few small LED point indicators that show information
about the state of the battery base unit. These are described in the table below.
Vista de página 6
1 2 3 4 5 6 7 8 9 10 11

Comentários a estes Manuais

Sem comentários