Robe Robin Cyclone Especificações descarregar pdf (Página 10)

3.4 DMX-512 connection

The xture is equipped with both 3-pin and 5-pin XLR sockets for DMX input and output.The sockets are wired

in parallel.

Only use a shielded twisted-pair cable designed for RS-485 and 3-pin or 5-pin XLR-plugs and connectors in

order to connect the controller with the xture or one xture with another.

DMX - output DMX-input

XLR mounting-sockets (rear view): XLR mounting-plugs (rear view):

If you are using the standard DMX controllers, you can connect the DMX output of the controller directly with the

DMX input of the rst xture in the DMX chain. If you wish to connect DMX controllers with other XLR-outputs,

you need to use adapter cables.

Building a serial DMX-chain:

Connect the DMX-output of the rst xture in the DMX-chain with the DMX-input of the next xture. Always

connect one output with the input of the next xture until all xtures are connected.

Caution: At the last xture, the DMX-cable has to be terminated with a terminator. Solder a 120 Ω resistor be-

tween Signal (–) and Signal (+) into a 3-pin (5-pin) XLR-plug and plug it in the DMX-output of the last xture.

1 - Shield

2 - Signal (-)

3 - Signal (+)

4 - Not connected

5 - Not connected

1 - Shield

2 - Signal (-)

3 - Signal (+)

4 - Not connected

5 - Not connected

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Sem comentários

Robe Robin Cyclone Especificações Página 10